Dual illumiNITE XNP553 User Manual

XNP693  
XNP653  
XNP553  
SBX693  
SBX653  
SBX553  
XNP-SBX SERIES  
INSTALLATION/OWNER'S MANUAL  
Car Audio Speakers  
XNP - SBX SERIES INSTALLATION  
Installation  
Please Note: Some Full Range Speakers are most often used as direct  
replacements for stock speakers and are shipped without grilles or grilles  
may not be required. Parts of the following instructions may not apply to your  
installation.  
The installation instructions included here are basic. If you feel  
unsure about installing the speaker system, Dual recommends  
that you seek installation by a qualified auto  
sound technician.  
Before installation, please follow these rules:  
1. Be sure to carefully read and understand the instructions before  
attempting to install the product.  
2. For safety, disconnect the negative lead from the battery prior to beginning  
the installation.  
3. For easier assembly, we recommend that if additional wiring is required,  
that you run all wires prior to mounting your speaker in place.  
4. Use the highest quality connectors for a reliable installation and to  
minimize signal or power loss.  
5. Use caution before you drill or cut! Be careful not to cut or drill into gas  
tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical  
wiring when working on any vehicle.  
6. Never run speaker wires underneath your vehicle. Running speaker wires  
inside the vehicle provides the best protection from exhaust heat and  
environmental elements.  
7. Avoid running wires over, near, or through sharp edged surfaces. We  
suggest you also use rubber grommets to protect any wires routed  
through metal, especially the firewall.  
8. Do not connect audio outputs from your amp or receiver to the Illuminite  
inputs of the speakers. This WILL DAMAGE the LED bulbs and WILL void  
your warranty.  
3
XNP - SBX SERIES INSTALLATION  
Lighting Hook-Up Recommendations  
The illuminite lighting elements of your XiN series products provide you with a unique  
custom touch to your vehicle. Dual’s patent pending illuminite bulb system and control  
circuitry provides an extraordinary lighted-Hue illumination which allows great creative  
opportunities for the beginner and seasoned custom installer alike. The interior of your  
vehicle will never sound or look ordinary again. Let your imagination take you there.  
The lighting features of all illuminite products require a 12 volt power source to operate.  
The speaker has two distinct sets of input terminals. The first is labeled audio input  
terminals and the second is labeled illuminite lighting inputs. The inputs are clearly  
marked with a label positioned directly above the terminal housing. The polarity (+ and -)  
indicators for each set of inputs also appear on these labels.  
1. Do not connect Amplifier or any audio source to illuminite lighting inputs. Inputs are  
designed for switched 12 volt power source only. More then 3V rms connected to  
illumination inputs can cause permanent damage to the lighting elements.  
2. See fig. 1a, (illustrates wiring diagram) be sure to maintain polarity. Be sure to connect  
to a constant switched 12 volt source. Correct connection would be the positive (+) 12  
volt wire to the Positive (+) illuminite Lighting input terminal and connect the Negative  
(-) illuminite lighting input terminal to a good chassis ground.  
Fig 1a  
Lighting Hook-Up From Rear  
12 volt source  
Audio Input  
Terminals  
Illuminite Lighting  
Input Terminals  
Head unit  
Ground  
Notice: The Illuminite™ series LED illumination elements are not removable. There  
are no serviceable parts inside or attached to the speaker assembly. The Illuminite™  
series products are sensitive electronic devices. Removal or tampering with any part or  
portion of the speaker and/or its assemblies will damage the product and void the limited  
warranty.  
4
XNP - SBX SERIES INSTALLATION  
Mounting  
1. Determine where the speakers will  
be mounted. Ensure an area large  
enough for the speaker to mount  
evenly. Be sure that the mounting  
location is deep enough for the  
speaker to fit.  
2. Refer to the specification chart to  
determine the proper diameter hole  
to cut for your speaker model.  
3. If supplied, use the plastic mounting  
ring as a template to mark the  
locations for the mounting screws.  
Drill the holes with a 1/8" bit.  
4. Be sure to observe proper polarity  
when connecting the wires.  
The speaker's positive terminal is  
indicated with the “+” symbol.  
5. Fit the ring and speaker to the cut-out.  
Mount them using the enclosed screws.  
If supplied, fit the grille inside the ring  
and press gently, but firmly, into place  
and attach with screws.  
5
XNP - SBX SERIES INSTALLATION  
Mounting Legend  
6
XNP - SBX SERIES SPECIFICATIONS  
Notes  
7
XNP - SBX SERIES WARRANTY  
Limited One-Year Warranty  
This warranty gives you specific legal rights.  
You may also have other rights which vary from  
state to state.  
What to do?  
1. Before you call for service, check your operating  
instruction booklet. A slight adjustment of any  
custom controls discussed in your instruction  
booklet may save you a service call.  
Namsung America Inc. warrants this product to  
the original purchaser to be free from defects  
in material and workmanship, under normal  
conditions, for a period of one year from the date  
of the original purchase.  
2. If you require service during the warranty  
period, you must carefully pack the product  
(preferably in the original package) and ship it by  
prepaid transportation with proof of the purchase  
date from the retailer to the Return Center  
address listed below.  
Namsung America agrees, at our option, during  
the warranty period, to repair any defect in  
material or workmanship or to furnish an equal  
new or renewed product in exchange without  
charges, subject to verification of the defect or  
malfunction and proof of the date of purchase.  
3. Please describe your problem in writing  
and include your name, a return UPS shipping  
address (P.O. Box not acceptable), and a daytime  
phone number with your shipment.  
During the One-Year Warranty Period: For One  
Year from the date of purchase, your product will  
be replaced with a new, renewed or comparable  
product (whichever is deemed necessary) if it  
becomes defective or inoperative. This is done  
without charge to you. Replacement products are  
warranted for the balance of the original warranty  
period.  
4. DUAL will pay the return shipping charges if  
the product is returned to an address within the  
USA.  
Namsung America Inc.  
Attn: Returns Center  
21318 64th Ave. South  
Kent, WA 98032 U.S.A.  
Toll Free: 1-866-626-7863  
Who is covered? This warranty is extended to the  
original retail purchaser for products purchased  
and used in the U.S.A., in the 48 contiguous states  
ONLY.  
Exclusion of Certain Damages: This warranty  
is exclusive and in lieu of any and all other  
warranties, expressed or implied, including  
without limitation the implied warranties of  
What is covered? This warranty covers all defects  
in material and workmanship in this product. The merchantability and fitness for a particular  
following are not covered: installation/removal  
costs, damage resulting from accident, misuse,  
abuse, neglect, product modification, improper  
installation, incorrect line voltage, unauthorized  
repair or failure to follow instructions supplied  
with the product, or damage occurring during  
return shipment of the product.  
purpose and any obligation, liability, right, claim  
or remedy in contract or tort, whether or not  
arising from the company’s negligence, actual  
or imputed. No person or representative is  
authorized to assume for the company any other  
liability in connection with the sale of this product.  
In no event shall the company be liable for  
indirect, incidental or consequential damages.  
Dual Electronics Corporation  
21318 64th Avenue South  
Kent, WA 98032 U.S.A  
©2005 Dual Electronics Corp.  
EVOK0404-V01  

Alpine Electronics Car Stereo System CDE 102E User Manual
AudioSource Car Amplifier 2 Channel Amplifier With Auto Switching Dual Inputs User Manual
Blaupunkt MINNESOTADJ30 User Manual
Burnham Independence IN3 User Manual
Casio Calculator SF 5980 User Manual
Cerwin Vega Heavy Duty Professional Amplifiers CV 2800 User Manual
Directed Audio 2300X User Manual
Hamilton Beach liquid blu 59207 B42 User Manual
Hypertec N16358NHY User Manual
ICP DAS USA IM 30 User Manual